Sig-sauer BLASER Tac2 Manuel d'utilisateur

Instruction manualWARNING !Please read and understand thisi n s t ruction manual entire l y,b e f o re using the rifle. Keep thismanual with your

104. Assembling, taking downWARNING:Make sure there are no cartridges inthe chamber or magazine.4.1 Assembling• Remove the large allen key (SW 4)from

114. Assembling, taking downfig. 4• Place both bolt rails parallel on the rearend of the receiver and insert the boltby sliding the bolt rails forward

125. Safety and bolt handle lock5.1 Safety systemThe safety system of the Blaser R 93 LRS 2 bolt action rifle is centered on theuncocked firing spring

135. Safety and bolt handle lockfig. 7 fig. 8 fig. 95.3 “On Safe“ position• To release the safety to the most rear-ward position place your thumb on t

146. Ammunition6.1 AmmunitionWARNING:Use only commercially available, CIPproofed ammunition in the originalpackaging, and which matches the cal-iber o

157. Magazine7.1 MagazineThe Blaser R 93 LRS 2 bolt action rifle isequipped with a removable single-rowmagazine. The detachable magazine isheld in the

168. Loading the rifleWARNING:Always keep muzzle of the rifle point-ed in a safe direction.Before loading, always wipe off anyexcess grease and oil, t

179. Firing and repeating9.1 Firing and repeating• Push the safety slide all the way for-ward with the thumb in the “off safe“position (see chapter 5.

1810. Unloading the rifle10.1 Unloading the rifle• Remove your finger from the triggerand point the rifle in a safe direction.• Move the safety slide

1911. Removing and replacing the bolt assemblyWARNING:B e f o re perf o rming any cleaning or maintenance, make sure there areno cartridges in t

2 R-93-LRS_2 6/8/01 2:32 PM Page 2

2012. Caliber group tableCaliber group Barrel and Bolt head Caliberare stamped withMini MI .223 Rem.Standard ST 6 mm Norma BR6,5x55.308 Win.Magnum MA

21There are 4 caliber groups available (seetable chapter 12). When changing thebarrel to a different caliber group, youwill also have to change the bo

2214. Changing the bolt headfig.14 fig.15 fig.1614.1 Changing the bolt headN O T E :It is advisable to have this operationexplained by your Blaser dea

23• Flip the retaining latch down again andpush it back into its recess so that itsnaps into position (fig. 18).• Lift the retaining latch in the bolt

24fig.20 fig.21NOTE:The bolt assembly can only be inserted in the receiver when the warning pin is flush in the bolt rail (fig. 20), indicat-ing that

25fig.2215. Trigger assembly15.1 Trigger assemblyThe Blaser R 93 LRS 2 bolt action rifle is equipped with an adjustable direct t r i g g e r. The trig

2616. Stock16.3 Cheekpiece:• After loosening cheekpiece knob thecheekpiece can be moved up or down.To remove the cheekpiece from thestock just pull it

2716. Stock R-93-LRS_2 6/8/01 2:32 PM Page 27

28• First thumb the front lever then therear lever back and down as far as theycan go. If you need to apply either noforce or a lot of force when doin

2918.2 Removing the scope• Grasp the rifle with your left hand around the fore-end and scope, steadying the rifle on your upper thigh.• Loosen the two

3 R-93-LRS_2 6/8/01 2:32 PM Page 3

3019. Optional accessoriesInterchangable barrelsBolt headMagazineMirage bandOriginal Blaser scope mount R-93-LRS_2 6/8/01 2:32 PM Page 30

3120. Care and maintenanceWARNING:Before performing any cleaning ormaintenance make sure there are no cartridges in the chamber or magazine.Always mak

3221. Warranty conditionsLIMITED 5 YEAR WARRANTYBLASER firearms are warranted by theBLASER Jagdwaffen GmbH to be free ofdefects in material or workman

33NOTES R-93-LRS_2 6/8/01 2:32 PM Page 33

34NOTES R-93-LRS_2 6/8/01 2:32 PM Page 34

35 R-93-LRS_2 6/8/01 2:32 PM Page 35

36Blaser Jagdwaffen GmbHD-88316 IsnyGERMANYom-LRS2-USA 8-2000 R-93-LRS_2 6/8/01 2:32 PM Page 36

4WARNING ! Please read and understand thisi n s t ruction manual entire l y,before using the rifle. Keep thismanual with your firearm. Uponchange of

5ContentsPage11. Safety rules 6 – 712. Main rifle components 813. Technical specifications 914. Assembling, taking down 10 – 1115. Safety and bolt han

61. Safety rulesYour new Blaser bolt action rifle model R 93 LRS 2 differs from other repeatersthrough a number of special design fea-tures. Although

71. Safety rulesBefore loading, check the barrel forobstructions and make sure no foreignmatter (water, snow, soil) can get intothe barrel after loadi

82. Main rifle componentsStandard delivery includes:1 Rifle1 Magazine1 Instruction manual1 T-Allen key SW 41 Allen key SW 32 Allen screws M5 x 25 R-93

93. Technical specificationsCaliber.223 Rem. 6 mm Norma BR 6 , 5 x 5 5 .308 Wi n . .300 Win Mag. .338 LapuaLength overall 44.5” 44.5” 44.5” 44.5” 45.3